Electricians

Garden Office Electrics: How to Plan the Supply in the UK

Planning power for a garden office in the UK: armoured cable, the sub-main and consumer unit, the earthing decision, Part P notification and a plan example.

4 min read · 21 November 2026 · RoomPlot Team

A garden office needs more than an extension lead through a window. It needs a properly protected supply from the house, buried safely, with its own small consumer unit. Planning the route on a drawing first saves digging twice.

PATIO GARDEN Desk Earth rod SWA House Garden office Garden office supply A sub-main to its own consumer unit Armoured sub-main, buried From the house consumer unit Office sockets Radial from the office unit Office lighting Earth rod, if designed as TT A design decision on PME supplies Connection (switch to light) SYMBOLS Consumer Unit Surface ceiling light Double socket One-way switch
A typical arrangement: an armoured sub-main from the house consumer unit to a small consumer unit in the office.

Key takeaways

  • The supply is normally a steel wire armoured (SWA) cable from the house consumer unit to a small unit in the office.
  • The cable is sized for the load and the length of the run, because voltage drop grows with distance.
  • The designer chooses whether to extend the house earth or give the office its own earth electrode.
  • A new circuit to an outbuilding is notifiable work in England and Wales.

Step 1 - List the load

Write down what the office will run: lighting, sockets for computers, and above all heating. A 2 kW panel heater changes the cable size more than everything else combined. Air conditioning or a workshop machine changes it again.

Step 2 - Choose the route

Measure the run from the house consumer unit to the office, including the distance inside the house. Keep clear of drains, tree roots and future building work. Armoured cable is buried deep enough to avoid damage from normal gardening, commonly around 500 mm or more, on a bed of sand with warning tape laid above it. It can also be clipped along a permanent wall.

Step 3 - Size the cable

The cable must carry the load and keep voltage drop within limits over the whole length. Long garden runs often need a larger cable than the current alone would suggest. This is a calculation for the electrician, using the measured route length.

Step 4 - Decide the earthing

Many houses have a PME supply. Taking that earth out to a building in the garden is a design decision, and the alternative is to make the office a TT installation with its own earth rod and RCD protection. The right answer depends on the site, and it is the designer's call.

Step 5 - The office consumer unit

A small unit in the office gives local isolation and separate protection for lighting and sockets, with 30 mA RCD protection. At the house end, the sub-main has its own protective device in the main consumer unit.

Check the rules. This is an overview for planning. The design, installation and certification are work for a registered electrician, and the job is notifiable under Part P in England and Wales.

Do not forget data

Wi-Fi rarely reaches the end of a garden reliably. Lay a duct for a data cable in the same trench, kept separate from the power cable, while the ground is open.

Draw it before you dig

Sketch the house wall, the garden and the office in RoomPlot, then draw the cable route as a dashed line. The app totals the length on plan, which gives the electrician the number they need for the cable calculation and gives you a record of where the cable is buried.

Frequently asked questions

Can I run a garden office from an extension lead?

Not as a permanent supply. Extension leads are not designed for continuous outdoor use or for heating loads.

How deep should armoured cable be buried?

BS 7671 asks for a depth sufficient to avoid damage. Around 500 mm or more is common in gardens, with warning tape above the cable.

Do I need planning permission for the electrics?

Planning permission concerns the building. The electrical work is covered by the Building Regulations, and a new circuit to an outbuilding is notifiable.

Free lesson. Want the full picture? Cable routes and schedules is part of our free electrical floor plans course, with interactive exercises.

Sources

Plan it on your phone. Plan the trench route, read off the cable length and keep a record of where the supply is buried. Download RoomPlot on the App Store and draw your first electrical plan in minutes, or see what it does on our electricians page.

Related guides

Electricians AFCI Requirements Explained: Which Rooms Need Arc-Fault Protection AFCI protection explained for US homes: what an arc fault is, the NEC 210.12 room list, what happens when you extend a circuit and how to plan it. 3 min read Electricians Consumer Unit Replacement in the UK: What Is Involved and What a Good Quote Includes Replacing a fuse box in the UK: what a modern consumer unit includes, the testing and certificates involved, Part P notification and how a circuit plan helps. 4 min read Electricians Cooker Circuit Guide: Cable Size, Diversity and the Cooker Switch UK cooker circuits explained: how diversity turns a 12 kW cooker into a 32 A circuit, typical cable sizes, where the cooker switch goes and how to draw it. 3 min read
Browse all guides