One ceiling light in the middle of the room is the classic living room mistake: too bright for a film, too dim for reading and flat all evening. Good living room lighting uses layers, each on its own control. This guide shows how to plan them step by step on a floor plan.
Key takeaways
- Use three layers: general light, a feature light, and accent or task lighting.
- Give each layer its own switch.
- Put a dimmer on the general layer.
- Place the furniture on the plan before the lights.
The three layers
- General light: recessed downlights or a ceiling light that lights the whole room evenly.
- Feature light: a pendant over a coffee table or dining table that sets the character.
- Accent and task light: wall lights, picture lights and lamps for reading and mood.
Step by step
- Draw the room with doors and windows, then place the furniture. The sofa and TV decide where light is needed and where glare will annoy.
- Place general light in a regular grid, roughly 1 to 1.5 m in from the walls in a typical room.
- Add the feature light over the coffee table or the middle of the seating area.
- Add wall lights on the walls you look at in the evening, not the ones behind the sofa.
- Put switches by the door on the latch side, one per layer, with a dimmer for the downlights.
- Link each switch to its lights so the plan shows exactly what each switch does.
Tip. Put the dimmer on the general light layer. It is the layer you most want to turn down in the evening.
Wiring it
All three layers usually sit on the downstairs lighting circuit. Each layer has its own switch drop, and the plan shows the cable route through the ceiling and the connection from each switch to the lights it controls. If the room has two doors, use two-way switching for the main layer so it can be turned on from either entrance.
Frequently asked questions
How many downlights does a living room need?
It depends on the room size and the output of the fitting. Four to six in a regular grid is typical for an average living room.
Should living room lights be dimmable?
Yes, at least the general layer. It is the one you most want to turn down in the evening.
Where should living room light switches go?
By the door, on the latch side. Use two-way switching if the room has two entrances.
Free lesson. Want the full picture? Lighting and switching is part of our free electrical floor plans course, with interactive exercises.
Plan it on your phone. Try different layouts, link every switch to its lights and share the plan with the client before first fix. Download RoomPlot on the App Store and draw your first electrical plan in minutes, or see what it does on our electricians page.