A three-way switch lets you control one light from two places: the top and bottom of the stairs, or both ends of a hallway. Add a four-way switch in the middle and you can control it from three or more. The names are confusing and the wiring looks like magic until you see it drawn.
Key takeaways
- Two locations: use two three-way switches. Three or more: add four-way switches between them.
- Two traveler wires run between the switches. The light is on when the path through them is complete.
- Stairways with six or more risers need a switch at each floor level.
- On a plan, three-way switches are marked S3 and four-way switches S4, each linked to the light.
Why "three-way"?
The name comes from the three terminals on the switch, not from the number of locations. One terminal is the common. The other two connect to the travelers. In the UK the same switch is called a two-way switch, counting the positions instead of the terminals, and a four-way switch is called an intermediate switch.
How it works
Power arrives at the common terminal of the first switch. The switch sends it down one traveler or the other. At the far end, the second switch connects its common terminal, which leads to the light, to one of the two travelers. If both switches select the same traveler, the path is complete and the light is on. Flip either switch and the path breaks.
A four-way switch sits on the travelers between the two three-way switches. It either passes the travelers straight through or crosses them over, so flipping it also changes the state of the light.
The cable
Between the switches you need a three-conductor cable, such as 14-3: two travelers and a neutral, plus ground. Current editions of the NEC require a neutral conductor at most switch locations so that electronic switches and dimmers have the power they need.
Where the code requires it
For interior stairways with six risers or more, the NEC requires a wall switch at each floor level and at each landing that includes an entryway, to control the stair lighting. That means three-way switching at the top and bottom. Long hallways and rooms with two entrances are not required to have it, but people expect it.
Check the rules. States and cities adopt different editions of the NEC, often with local amendments. This guide is a plain-English summary based on recent editions. Always check the edition your jurisdiction enforces and ask your inspector when in doubt.
Drawing it on a plan
A plan does not show the travelers. It shows the result: which switches control which light.
- Place the light symbol.
- Place a three-way switch symbol at each of the two locations, and a four-way switch at any location between.
- Draw a connection from each switch to the light.
In RoomPlot the two-way and intermediate switch symbols are the same devices a US electrician calls three-way and four-way. Connections are drawn as thin red curves, so anyone reading the plan can see that three switches share one light, and the electrician knows to pull three-conductor cable between them.
Stay safe. Switch off the breaker and confirm the circuit is dead with a tester before opening any switch box. If the wiring does not match what you expect, stop and call a licensed electrician.
Frequently asked questions
Can I use a three-way switch as a single-pole switch?
Yes. Connect the common and one traveler terminal and leave the other unused. The reverse does not work.
How many four-way switches can I add?
As many as you need. Every additional control location between the two three-way switches uses one four-way switch.
Do three-way switches need special dimmers?
Use a dimmer rated for three-way circuits, and normally only one dimmer per light, unless you choose a system with companion dimmers.
Free lesson. Want the full picture? Lighting and switching is part of our free electrical floor plans course, with interactive exercises.
Sources
- NFPA 70, National Electrical Code: free online access and development
- NFPA: NEC adoption maps by state
- Electrical Safety Foundation International (ESFI)
Plan it on your phone. Link every switch to the light it controls and make multi-location switching obvious on the plan. Download RoomPlot on the App Store and draw your first electrical plan in minutes, or see what it does on our electricians page.