Electricians

Smart Home Wiring Plan: What to Build In Before You Plaster

Plan smart home wiring before plastering: neutrals at switches, deep back boxes, Cat6 to TVs and access points, and a home for the network cabinet.

3 min read · 20 November 2026 · RoomPlot Team

Most smart home products are sold as wireless, but the homes where they work best were wired for them. A few decisions at first fix, such as a neutral at every switch and data cable to the right places, make every smart device that follows easier to install and more reliable.

PLAN BEFORE YOU WIRESmart home wiring checklist BUILD IN NOW Neutral at every light switch Deep back boxes for smart switches and dimmers Cat6 to the TV, office and each Wi-Fi access point Power and data at ceiling level for access points A ventilated spot for the network cabinet AVOID Relying on Wi-Fi alone for cameras and doorbells Switches with no neutral in the box A consumer unit with no spare ways Data cables run tight alongside power cables
What to build in before plastering, and what to avoid.

Key takeaways

  • Bring a neutral to every switch position.
  • Fit deep back boxes for smart switches and dimmers.
  • Run Cat6 to TVs, desks, ceiling access points and cameras.
  • Bring every data run back to one cabinet.

Neutral at every switch

Many smart switches and dimmers need a neutral conductor in the switch box. Older wiring often only brings the switched line down to the switch. Bringing a neutral to every switch position during a rewire is a small cost that keeps every smart switch option open.

Deep back boxes

Smart switches and dimmers are deeper than standard ones. Fitting deeper back boxes at first fix avoids chasing walls again later.

Data where it matters

  • Cat6 to the TV wall, the home office and the games console.
  • Cat6 to the ceiling for Wi-Fi access points on each floor.
  • Cat6 to camera and doorbell positions, ideally with Power over Ethernet.
  • All runs back to one network cabinet in a ventilated spot.

Tip. Draw data in its own colour on the plan. It reminds everyone that it is a separate system that should not share a route with mains cable.

Plan the cabinet

The network cabinet needs power, ventilation and room for a router, switch and patch panel. Under the stairs or in the garage near the consumer unit are common spots. Our guide to placing motion sensors covers the security side of a smart home.

Frequently asked questions

Do smart switches need a neutral wire?

Many do. Some work without one, but a neutral at the switch gives the widest choice of products.

Is wired better than wireless for a smart home?

For fixed devices such as TVs, access points and cameras, wired data is more reliable. Wireless suits sensors and lamps.

Where should the network cabinet go?

Somewhere ventilated with power nearby, such as under the stairs or in the garage.

Free lesson. Want the full picture? Lighting and switching is part of our free electrical floor plans course, with interactive exercises.

Plan it on your phone. Plan neutrals, data and the cabinet on the floor plan before the plasterer arrives. Download RoomPlot on the App Store and draw your first electrical plan in minutes, or see what it does on our electricians page.

Related guides

Electricians AFCI Requirements Explained: Which Rooms Need Arc-Fault Protection AFCI protection explained for US homes: what an arc fault is, the NEC 210.12 room list, what happens when you extend a circuit and how to plan it. 3 min read Electricians Consumer Unit Replacement in the UK: What Is Involved and What a Good Quote Includes Replacing a fuse box in the UK: what a modern consumer unit includes, the testing and certificates involved, Part P notification and how a circuit plan helps. 4 min read Electricians Cooker Circuit Guide: Cable Size, Diversity and the Cooker Switch UK cooker circuits explained: how diversity turns a 12 kW cooker into a 32 A circuit, typical cable sizes, where the cooker switch goes and how to draw it. 3 min read
Browse all guides