Module 1 · Foundations · Lesson 4 of 18

Drawing the base plan: measuring, doors and fixed fittings

Free lesson: how to capture an accurate base plan for electrical design, with walls to scale, door swings, windows and fixed fittings.

6 min · 0 XP · 0 of 18 lessons done

Lesson 4 of 18 All lessons
  1. 1What an electrical floor plan is, and who uses it
  2. 2Electrical symbols: lights, switches, sockets and distribution
  3. 3Circuits explained: lighting, rings, radials and dedicated supplies
  4. 4Drawing the base plan: measuring, doors and fixed fittings
  5. 5Lighting and switching: one-way, two-way and intermediate
  6. 6Sockets and spurs: how many, where, and on which circuit
  7. 7Kitchens and bathrooms: special rules for special rooms
  8. 8Cable routes, lengths and circuit schedules
  9. 9Dedicated circuits: showers, cookers, EV chargers and outbuildings
  10. 10UK rules: BS 7671, Part P and what applies where
  11. 11UK protection: consumer units, RCD types and surge protection
  12. 12UK earthing systems, mounting heights and certificates
  13. 13US rules: the NEC, receptacle spacing, GFCI and AFCI
  14. 14US kitchens and bathrooms: receptacle rules on the plan
  15. 15US panels, GFCI, AFCI and wire sizes
  16. 16Worked example: from survey to a finished plan
  17. 17Checking your plan and handing it over
  18. 18Final test: check what you have learned

In this lesson

  • Electrical design is only as good as the plan underneath.
  • Door swings decide where switches go.
  • Draw kitchens and bathrooms before any electrics.

Every good electrical plan sits on an accurate base plan. In this lesson you will capture one: walls to scale, doors with their swings, windows and the fixed fittings that decide where electrics can go.

Kitchen Bathroom Bedroom Garage The base plan Walls, doors, windows, fittings CIRCUITS (CABLE ROUTES) Walls to scale Measured or scanned Door swings Decide switch positions Windows Keep clear of fittings
A base plan ready for electrical design: walls to scale, door swings, windows and fixed kitchen and bathroom fittings.

Measure or scan

Measure each room with a laser measure, or scan it. On a LiDAR iPhone or iPad Pro, RoomPlot builds walls, doors and windows from a scan; on other devices you draw the walls with snapping. Check overall dimensions, because small errors add up across a house.

Doors and windows

Draw every door with its hinge side and swing. The latch side is where a light switch belongs. Windows matter too: they limit where sockets, radiators and wall lights can go.

Fixed fittings first

Add the worktops, sink, hob, bath, shower and WC before any electrical points. Kitchens and bathrooms have their own rules, and the fittings decide what is allowed where.

Heights

A floor plan is two dimensional, so write heights down. For new homes in England, Approved Document M points switches and sockets to between 450 mm and 1200 mm above finished floor level.

Try it

Draw one room of your home with its door swing, windows and fixed furniture. Mark the latch side of the door.

Check your understanding

Official documents and further reading

Progress is saved in this browser.

Go deeper: related guides

Electricians How to Read an Electrical Plan: A Beginner's Guide Learn to read an electrical floor plan in five steps: symbols, switch connections, cable routes, circuits and the consumer unit, with a worked example. 3 min read Electricians How to Draw an Electrical Plan on iPhone or iPad Draw an electrical floor plan on iPhone or iPad in six steps with RoomPlot: scan or draw, place symbols, link switches, route cables and export. 3 min read